Use
• Evenly spread the electric underblanket over your mattress. Start at the foot end of
the mattress. By means of the four attachment straps you can attach the blanket to the
mattress, so it cannot shift.
• Place the short straps around the corners of the mattress at the foot end and the long
straps around the corners of the mattress at the head end.
Important: No heating is allowed under the pillow and for that reason the loops on
that side are longer. For a pillow, approx. 50 cm is taken into account. It is the head that
ensures that the body cools down when it is too hot. So if you were to heat your head,
your body would become overheated, which is bad for your health.
• The electric underblanket can be used on both sides, so that you can decide for yourself
on which side (left or right) you want the connection.
• Connect the switch to the connection point in the blanket by connecting the plug.
Approximately, the cord should be at shoulder height.
• Then insert the plug in the socket.
• Then, as usual, lay the fitted sheet over the bed, so that the electric underblanket is
between the mattress and the fitted sheet.
• Each time you make the bed, check that the electric underblanket is flat and properly
spread, before you switch it on.
CAUTION!
Make sure the electric underblanket is spread out fully flat and does not fold or crumple during use. We recommend
switching on the electric underblanket about 15 minutes before you go to sleep and covering it with a duvet to prevent
the heat from escaping.
Switching on
Slide the position button from position 0 to position 1,2 or 3 to switch on the electric underblanket.
In activated condition, the indication light is illuminated.
Setting the heating position
Position 0: OFF
Position 1: minimum heating
Position 2: medium heating
Position 3: maximum heating
ATTENTION
•
The electric underblanket heats up the fastest when you first switch on the highest temperature level.
WARNING:
If the electric underblanket is used for several hours, we
recommend setting the lowest heating position (position 1) to
prevent the user from overheating and thereby any potential
burns to the skin or heat stroke.
EN - 19
150 cm
80 cm