Coccolle Aspen Mode D'emploi page 13

I. Five-point seat belt use
1. Bring all 4 belts to the centre and buckle them in the central buckle (fig. 25).
2. To open, press the buckle and the belts will pop out.
3. To adjust the length, pull the adjusting button up and down to adjust the
length according to your child's height.
J. Brake operation
1. When the brake pedal is pressed down, the rear wheels will not move (fig.
26).
2. Lift the pedal to push the stroller normally.
3. Always push down the brake during parking and whenever you are putting in
or removing the child.
K. Folding
1. Fold the backrest over to the front side by pushing the button and backrest
forward (fig. 27-28).
2. After adjusting the height of the handlebar to the lowest position, press the
buttons on the handlebar and leave it to slide down (fig. 29-30).
3. At the folding articulation, there is a handle. Pull it out in order to complete
folding (fig. 31).
4. The seat folds in the same manner regardless of the seat position, forward or
rearward facing (fig.32).
L. Stroller opening after fold
1. Open the seat by pulling it upwards, then proceed to lifting the handle. After
that, make sure that the stroller has opened onto all four wheels. Check for the
frame and all it's articulations to be locked in place (fig.33).
2. The same steps are to be done regardless of the seat position, forward or
rearward facing.
M. Carrycot operation
1. With the carrycot facing up, pull the metal bar upwards then snap the iron
wire into the buckle (fig. 34).
2. To operate the canopy, push both buttons on the sides of the carrycot and
push down or lift up the canopy (fig.35).
3. To assemble the carrycot liner, put the liner in the canopy and using the
zipper line (fig. 36).
4. To use the parasol, simply pull it out from under the canopy (fig.37).
N. Car seat connection
1. You will find included in this package a set of adapters that will connect your
infant carrier to
it the mounted piece into the stroller frame. Be aware to use the correct side,
adapters are marked left and right.
2. To remove the adapters, simply press the button above the mount, around the
lateral side of the canopy and remove the adapter from the carrier.
3. Be aware of the safety warnings for the infant car seat, respect them and do
not overload!
4. This type of adapters will match our own brand (Coccolle) car seat, as well as
certain models from Maxi Cosi and Cybex. Contact your retailer for detailed
information.
the stroller frame. Insert the adapter in the car seat that insert
13 13
EN