Gardebruk 990744 Mode D'emploi page 6

 In the case of a reinforced concrete foundation, lay a first layer of stones or gravel. The
foundation should have a thickness of at least 10 cm. Allow the concrete to dry for at least
48 hours.
 Foundations can also be created from bricks, stone blocks or concrete beams.
 The shed is not designed to be erected directly on a lawn.
 Your shed must be firmly anchored to the foundation to prevent damage from strong winds.
Anchors are not included in the delivery.
 Do not store chemicals in your shed. Flammable, harsh or corrosive materials must be stored
in airtight and appropriately approved containers.
 More than 10 cm of snow accumulation can be dangerous!
 ATTENTION! Do not stand on the roof! Danger of collapse!
 Avoid overhanging trees wherever possible, as falling leaves require regular clearance and
breaking branches are a potential source of danger.
 Small trees, bushes or fences nearby can be helpful as windbreaks.
 ATTENTION! Keep small children away during assembly as there is a risk of injury!
 Note: A suitable Phillips screwdriver, a cordless screwdriver, a tape measure, a cutter knife, a
ladder, a spirit level and protective gloves are required for assembly.
INTENDED USE
The storage shed is intended for the storage of garden tools, bicycles and leisure equipment. The
storage shed is not suitable for the storage of hazardous materials or for the accommodation of
people or animals. Use the product only for the purpose it is intended for. The manufacturer
accepts no liability for damage caused by improper use. Any modification to the product may
negatively impact safety, cause hazards and invalidate the warranty.
Only suitable for domestic use; not for commercial use.
UNPACKING INSTRUCTIONS
Open the box and remove all parts and elements in the set. Place the components on the top of
the box or other clean surface. This will protect your new product. After unpacking, please check
the product for damage and to ensure it is complete. Subsequent complaints cannot be accepted.
CHOOSING A LOCATION
Before you start assembly, familiarise yourself with relevant local rules and regulations. When
choosing the most suitable location for the shed, ensure that the ground is solid and level and do
not choose a site where the shed would be completely exposed to the elements! A certain degree
of protection against strong winds and stormy conditions must be present. Without this, damage
may occur.
ASSEMBLY
Follow the diagrams illustrating the construction steps.
When assembling, always wear safety gloves, long sleeves and protective goggles. Some parts
may have sharp edges that could cause injury!
 Make sure the day you choose for installation is dry and calm.
 Keep children and pets away from the installation site.
 Remove all protective film before assembly.
 Only use screws with plastic washers for pre-painted surfaces.
6 www.DEUBAXXL.de