Fagor Stellar 200 Mode D'emploi page 14

■ PRODUCT DESCRIPTION
S
tellar 200 is a programmable unit that includes high selectivity filtering up to 32 channels from any
of its four VHF / UHF inputs, converting them to any output channel. All the output channels are
combined in one equalized RF output that can be amplified to an optimum level for distribution.
As it's provided with an embedded display and keypad, it's appropriated to adjust the channels and
output level at the same installation, to successfully distribute the signals within a multi-dwelling
building.
Main features:
• 32 filters of variable bandwidth and high selectivity for the
conversion of the terrestrial TV input channels.
• Internal Pre-Amplifier with Automatic Gain Control (AGC) to
compensate the input signals differences.
• 1 VHF input and 3 UHF inputs to choose the best input for each
input channel to be processed.
• SAW filter of the 5G band on each UHF input, to minimize the interference of these signals.
• Output level configuration up to 113 dBµV to increase the signal distribution.
• Automatic measurement of the level of the input channels to be processed.
• Auto-Scan: Automatic search of the existing channels in each RF input.
• Channels and output level programming in an intuitive way through keypad and LCD display.
• Possibility of configuring through an Android APP.
■ INSTALLATION AND START-UP
• Connect the equipment ground point to the installation ground point, (6), page 2 Controls.
• Connect the antennae cables to the corresponding inputs and close the free inputs with 75 charges
(Ref. 84011). Connect the output cables to the signal distribution network.
• Connect Stellar to the electrical mains.
• Stellar is an indoor unit designed to operate in a temperature range of 0~50ºC, but it's recommended
to install the device in a temperature-controlled environment to ensure its optimum behavior and to
maximize the product life. Also, it is necessary to not expose the unit to rain or moisture.
■ MODULE CONFIGURATION
Stellar can be configured by the user in two ways:
• With an Android device connected by USB to the Stellar. For correct operation, the USB connection
cable must be OTG, like the one included as an accessory. The APP to configure the Stellar can be
downloaded from the Google Play Store or from FAGOR website.
• Through the display included in the module that allows checking and modifying its parameters'
configuration. A keypad is also provided with the module, consisting of four buttons with arrows, that
allows the user moving through the configure menu diagrams shown in pages 6 and 7.
Display function
First line indicates the parameter group to
be accessed or the parameter to configure.
Second line shows the parameter to be
accessed or its actual value.
Key buttons functions
The buttons with the up / down arrows allow:
• Choose a parameter group or a parameter.
• Change the value of a parameter.
The buttons with the left / right arrows allow:
• Enter or exit the menu function.
• Move along the characters of a parameter value.
14