Evolite HAZER PRO 2000 Mode D'emploi page 10

o DMX 512 connection
The wires must not come into contact with each other, otherwise the fixture will not work at all or properly. Please note the starting
address depends upon which controller is being used. Only use a DMX cable and 3-pin XLR-plugs and connectors in order to connect
the controller with the fixture or one fixture to another
Connection with the mains.
The earth has to be connected. The device must only be connected with an electric installation carried out in compliance with IEC
standards.
o DMX-protocol
Channel
CH 1
CH 2 Control speed of fan
CH 3 Control qty of fluid
HAZER PRO 2000 Manual Ver. 1.00[Texte]
Function
Hazer
DMX value
0~127 off, 128-255 on
0~255 from small to large
0~255 from small to large
Page 10