Home Decorators Collection DINTON 72009 Guide D'utilisation Et D'entretien page 8

Assembly - Standard Ceiling Mount (continued)
4
Assembling the fan
WARNING: Failure to properly install the locking pin (DD) could
result in the fan becoming loose and possibly falling.
□
Loosen, but do not remove, the set screws (GG) on the collar on
top of the fan-motor assembly (E).
□
Align the holes at the bottom of the ball/downrod assembly (B)
with the holes in the collar on top of the fan-motor assembly (E).
□
Carefully insert the hanger pin (CC) through the holes in the collar
and ball/downrod assembly (B). Be careful not to jam the hanger
pin (CC) against the wiring inside the ball/downrod assembly (B).
□
Insert the locking pin (DD) through the hole near the end of the
hanger pin (CC) until it snaps into its locked position.
□
Re-tighten the set screws (GG) on the collar on top of the fan-
motor assembly (E).
Assembly - Hanging the Fan
1
Attaching the fan to the electrical box
WARNING: To reduce the risk of fire, electric shock or personal
injury, mount to outlet box marked "Acceptable for fan support
of 35 lbs. 15.9 kg) or less", and use screws provided with the
outlet box.
NOTE: The mounting bracket (A) is designed to slide into place on
an outlet box with the outlet box screws (JJ) installed.
□
Loosen the two mounting screws (JJ) in the outlet box.
□
Pass the 120-Volt supply wires through the center hole in the
mounting bracket (A).
□
Slide the mounting bracket (A) on to the mounting screws (JJ)
and center the mounting bracket (A) in relation to the outlet box.
If necessary, use leveling washers (not included) between the
slide-on mounting bracket (A) and the outlet box. The flat side of
the slide-on mounting bracket (A) should face toward the outlet
box, as shown.
□
Securely tighten the two mounting screws (JJ).
CC
8
C
FF
D
DD
B
GG
E