Home Decorators Collection DINTON 72009 Guide D'utilisation Et D'entretien page 7

Assembly - Standard Ceiling Mount
1
Preparing for mounting
NOTE: The magnet is pre-attached on the canopy bottom
cover (FF) for you to remove and install easily.
□
Pull off the canopy bottom cover (FF) from the canopy (C).
□
Loosen the two canopy screws (GG) located in the
bottom of the mounting bracket (A), and turn the canopy
counterclockwise to remove the mounting bracket (A)
from the canopy (C).
3
Routing the wires
□
Route the wires exiting the top of the fan motor assembly (E)
through the decorative motor collar cover (D) and then the
center of the canopy bottom cover (FF).
□
Make sure the opening of the canopy (C) is on top and insert
the ball/downrod (B) through the canopy (C).
□
Route the wires exiting the top of the fan motor assembly (E)
through the downrod as shown.
2
Installing the blades
□
Attach a blade (F) to the fan-motor assembly (E) by
inserting the blade (F) into the slots in the side of the fan
motor housing and aligning the three screw holes in the
blade with the holes in the center flywheel and secure
with screws (AA).
□
Make sure all the screws are firmly tightened.
□
Repeat these steps for the remaining blades.
A
GG
C
FF
7
F
E
Please contact 1-800-986-3460 for further assistance.
C
FF
D
B
HOMEDEPOT.CA