Joycare JC-138G Mode D'emploi page 9

All manuals and user guides at all-guides.com
GENERAL INFORMATION
Mean temperature varies from person to person depending on sex, age
and different parts of the day. It can go from a minimum of 35.5°C (95.9°F)
to 37.8°C (100.4°F). Thereby, when you are in good health, it is suggested
to effect different consecutive measurements to state the range of your
own mean temperature.
READ ACCURATELY USER MANUAL PRECAUTIONS
- Use the device only with the aim it was built for.
- To do accurate measurements, be sure that the probe is integral, clean and
dry (see maintenance).
- Avoid measuring your temperature for at least 30 minutes after having done
an intense physical work, having eaten and having had a bath.
- Don't expose the instrument to high temperature, to direct sunbeams and
to dust.
- Keep the thermometer in its holder.
- Avoid to knock it off.
- Be careful to follow the instructions for a correct position and use.
- Don't try to open or repair the instrument alone: the guarantee would decay.
- Don't disassemble the instrument, except to remove or substitute the
battery.
- In case of breakdown turn to a specialized centre.
- Don't put fingers or objects into the probe.
- To clean the instrument use a soft cloth soared with alcohol; never use
aggressive chemicals or detergents.
- To clean the probe use some cotton soared with alcohol.
HOW TO PROCEED TO MEASURE
- Push the switching on button: to be sure of a correct operation, when
you switch on the device check that display shows in order: all the
segments lighted for few seconds the last temperature detected.
- Bring the thermometer's probe near to forehead in the centre, under
the hairline.
- Press the SCAN button for 3-4 seconds. Release the button and wait for
the sound to display the temperature measured.
- The temperature will be detected in 3-4 seconds and display will
immediately visualize it.
Note: If you dry or wash your forehead, skin could become cooled. As a
result measurement of the temperature could not be reliable anymore.
- If the detected temperature seems to be not reliable or instable, it is
suggested to call the authorized service to check that the device works
correctly or call our own doctor for a consulting.
- Push the button again to effect a new measurement.
- Before going on measuring, make sure your skin to be dry and clean
(skin must be always clean, not sweaty, not wet of water or oil). Follow the
instructions with attention and move delicately the thermometer, in light
contact with skin.
9