Powerfix Profi PDFP 500 D4 Mode D'emploi page 6

Use
♦ Undo the elastic fastening bungee and unfold the product until it audibly
clicks into place (see fig . 1) .
♦ Press the knob on the handle and pull the telescopic bar out until it clicks
into place (see fig . 2) .
► Do not stretch the fastening bungee more than the maximum usable
length of 130 cm . Keep your eyes, face and unprotected body parts
out of range of a possible springback .
NOTE
► The fastening bungee must be under tension to ensure that the load is
held in place . Observe the size of the load .
► Never apply a load of more than 50 kg .
♦ Place a load onto the load area . Do not stack multiple loads .
♦ Place the load centrally on the load area .
♦ Secure the load with the fastening bungee (see fig . 3) .
♦ Make sure that the fastening bungee is sufficiently tightened so that the load
is firmly held in place .
♦ Also make sure that the fastening bungee is sufficiently tightened even for
small loads (see fig . 4) . The arrow symbol
bungee can be hooked on .
♦ Move the product by pulling it behind you on both wheels .
1
■ 4 │ GB │ IE │ NI
WARNING! RISK OF INJURY!
shows where the fastening
2
PUTK 50 A1