Publicité
EN
Memory Height 2
Memory Height 1
Memory Height: Standing
LED Display
Up/Down
Memory Save/
Child Lock
Height-saving Function
Adjust the Anti-collision Sensitivity
Code Processing
USB Charging
a. USB port output: QC2.0/QC3.0, 5.0V/9.0V/12.0V, ±5%, current: 1.0A.
Operation Instruction
USB
Memory Height:
outlet
Sitting
a. Use "
" or "
" to adjust desk to desired height, press M,display screen show "
saved, display screen show "
" or "
b. Press the " 1 ", " 2 ", " ", or " " button to automatically adjust the standing desk to the previously saved position.
a. Press and hold the "
" and "
" buttons simultaneously for 5 seconds to switch the sensitivity. Each operation will switch to the next level,
with a total of 4 levels (A-3, A-2, A-1, A-0).
b. The LED screen will display "
" to deactivate the anti-collision function,"
sensitivity.
c. When the desk encounters an obstacle while raising or lowering, it will immediately bounce back to protect the desk and prevent any
damage.
a. Reset: when LED display "
" or "
reset complete and the desk can be used normally.
b. If you see "E01" or "E02", allow the desk to rest for at least 18 minutes before using it again.
c. If you encounter any other error codes and the "
properly connected. Disconnect the power for at least 10 seconds, then reconnect it. The LED screen will display "
hold the "
" button to reset.
d. If you have followed the above steps and the desk still does not function properly, please contact customer service for further assistance.
Height Adjustable Function:
Child Lock Function:
" or "
" or "
".
" for low sensitivity, "
", press "
" to lowest height , keep pressing "
" button does not respond, please check if the connection cable is undamaged and
By pressing the "
" or "
" button, you can adjust
the height of the desk by moving it up or down. The
current height will be displayed on the LED screen.
a. To disable or enable the child lock, long-press
the M button for about 5s.
b. When the child lock is activated, the blue
indicator light for the child lock
(above "
" and "M") will illuminate.
c. Pressing any button will cause the indicator
light to flash once.
d. Only by disabling the child lock function, all
buttons work normally
" then press buttom " 1 " or " 2 " or "
" or "
" for medium sensitivity,"
" until desk rebound up and stop, LED display "71.5",
" or "
" , height
" for high
". Press and
14
Publicité
