BGS technic 8301-1 Manuel D'utilisation page 5

USE OF TOOLS 1, 3, 4, 8, 9 and 10
If present, cut the old ribbed belt using a suitable tool.
Choose a suitable distance bolt.
Place tool on the pulley and adjust the distance bolt so
that the tool is placed flat on the pulley.
Place the new ribbed belt over all rollers and finally over
the tool, as described in the service literature.
By turning the crankshaft, pull the ribbed belt onto the
crankshaft pulley.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed