Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
5) If there is no air gap, make sure to suspend the middle of
the drain hose well above the sink cabinet base to
prevent back flow (see Fig. 20 ).
A
C
B
•
A Sink
•
B Min. 20" (508 mm)
•
C Min. 30" (762 mm)
•
D Drain hose
•
E Dishwasher
6) When drilling a hole for the drain hose on the cabinet
wall, make sure the drain hose is not damaged by the
sharp edges of the hole. On wooden walls, sand the hole
to soften the edges. On metal walls, use insulation tape
or duct tape to cover the sharp edges around the hole.
7) Take care not to damage the drain hose when installing
the dishwasher on the floor, wall, or cabinet. To prevent
leaks or drainage problems, make sure the drain hose is
not damaged, kinked, or twisted.
8) Do not cut the wrinkled area of the drain hose to fit the
size. When arranging the drain hose, make sure not to
touch the sharp edges of the cabinet or under-sink.
•
Be careful when cutting off the end of the drain hose as
there is a risk of injury. Clean around the sink drain
connection so that it does not damage the hose. Check
for any foreign items in the drain hose and remove them.
•
When arranging the drain hose, make sure the drain
hose is not cut, torn, or broken by any sharp edges on
the floor, the product itself, or the cabinet. A damaged
drain hose causes a leak.
ADJUSTING THE MOVABLE TOE KICK (DEPENDING
ON MODEL)
Now that you have successfully installed the dishwasher,
you need to attach the toe kick to the dishwasher. The two-
piece toe kick can be adjusted to the height and depth
needed for your kitchen.
Fig. 19
1)
•
A. If the height is 34" to 36" (864mm-914mm) and
using short supports: adjustable plinth metal 3 1/8"
(80mm) in length (v), toe kick brackets (o) are
installed. Mounting is done using Screws 5/32" x 7/
32" (4mm x 6mm) with a Phillips Screwdriver.
•
B. If the height is over 36" (914mm) and using short
supports: adjustable plinth metal 5 1/8" (130mm) in
length (v), toe kick brackets (o) are installed.
Mounting is done using Screws 5/32" x 7/32" (4mm x
6mm) with a Phillips Screwdriver.
o
Fig. 20
2) The adjustable plinth number is determined according to
the required distance and assembled to each other.
3) As shown in Fig. 22 , the cylindrical feet of the adjustable
plinth are attached to the plinth fixing metal parts and
inserted through the cavity of the part.
Depending on the desired depth, plinth locking (y) is
attached to the toe kick bracket (o).
t
E
p
Fig. 21
21
Publicité
