Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
PLACEMENT OF DISHWASHER INTO THE OPENING
Now place the dishwasher into the opening and get ready
to connect all hoses and electrical connections.
CAUTION
Make sure that all hoses are pulled through
the side opening of the cabinet, that no
hoses are kinked and that all slack is taken
out as shown in the figure.
DRAIN HOSE CONNECTION
1) Check the parts on the sink to which the drain hose will
be connected.
2) There are several ways to insert the drain hose into the
drain hose connector of the sink, as shown in the
following figures. You must connect the drain hose in
accordance with the water pipe installation regulations in
your region.
GARBAGE
WITH AN AIR
DISPOSAL
•
A Air gap
•
B Drain hose
•
C Hose clamp
20
WITHOUT AN
GAP
AIR GAP
A
B
C
GARBAGE
DISPOSAL
•
A Air gap
•
B Drain hose
•
C Hose clamp
3) Check the size of the sink drain hose connector. If
needed, cut the drain hose so its end fits onto the sink
connector (5/8", 3/4". or 1". - as shown in Fig. 18 ). If the
end of the drain hose does not fit onto the drain hose
connector of the sink, use an adapter purchasable at a
plumbing/hardware supply store.
Fig. 17
If necessary, cut off the dotted line of the drain hose to fit
the size.
4) Slide a hose clamp over the end of the drain hose.
Attach the drain hose to the sink connector, slide the
hose clamp to the end of the hose, and then tighten the
hose clamp.
NOTE
You must use a hose clamp. Failure to do
so may cause water leakage.
Use a hose clamp as shown in Fig. 19 for assembling the
drain hose to the sink.
WITH AN AIR
WITHOUT AN
GAP
AIR GAP
A
B
C
Fig. 18
Publicité
