Braun CruZer3 2874 Mode D'emploi page 9

English
Our products are designed to meet the highest standards of
quality, functionality and design. We hope you entirely enjoy
your new Braun shaver.
Warning
Your shaver is provided with a special cord set with an
integrated Safety Extra Low Voltage power supply. Do not
exchange or manipulate any part of it. Otherwise there is risk
of electric shock.
For usage in other body areas, please make sure that the
skin is stretched.
For hygienic reasons, do not share this appliance with other
persons.
Description
1 Foil protection cap
2 Shaver foil
3 Cutter block
4 Styler
4a Wide shaper (28 mm)
4b Narrow shaper (14 mm)
5 Charging light
6 On/off switch
7 Trimming attachment
8 Beard length setting
9 Special cord set
10 Charging stand
Charging
The best environmental temperature for charging is between
15 °C and 35 °C.
• Using the special cord set, connect the shaver to an
electrical outlet with the motor switched off.
• When charging for the first time, leave the shaver to
charge continuously for 4 hours. The green charging
light (5) shows that the shaver is being charged. When
the battery is fully charged, the charging light intermit-
tently blinks on and off. This indicates that the battery
maintains its full capacity.
• A full charge provides 30 minutes of cordless shaving
time depending on your beard growth.
• Once the shaver is completely charged, discharge the
shaver through normal use. Then recharge to full ca-
pacity. Subsequent charges will take about 1 hour.
• Maximum battery capacity will only be reached after
several charging/discharging cycles.
• If the rechargeable batteries are discharged, you may
also shave by connecting the shaver to an electrical
outlet via the special cord set.
Shaving
First, remove the trimming attachment: Using your thumbs,
press against the side clips of the trimming attachment so
that they swing off in the direction of the arrows (a).
9