Eternico AET-MS430S Serie Manuel D'utilisation page 7

INSTRUCTIONS
Inserting and replacing the battery
You must insert a battery to control the mouse. Proceed as follows:
1. Turn the mouse upside down and remove the battery compartment cover.
2. Insert a new 1.5V AA alkaline battery. Observe correct polarity when inserting the battery;
it is marked on the bottom of the battery compartment.
3. Replace the cover.
When you replace the battery proceed in the same way, except remove the spent battery.
Installation
The USB receiver is located in the space next to the battery. Turn the mouse upside down and
remove the battery compartment cover. Remove the USB receiver from the inside of the mouse
and insert it into the USB-A port of your computer. Switch the main switch to position ON.
The mouse is installed automatically so you can control the mouse quickly and comfortably.
Once the cursor appears on the screen, the mouse is ready to use.
Cleaning
Keep the wireless mouse clean. Switch the main switch to position OFF.
Use only a dry, clean cloth for cleaning. Do not use harsh cleaners, solvents, gasoline or other
similar substances. Never wash the wireless mouse with water and do not immerse it in water.
If you will not be using the wireless mouse for an extended period of time, set the power switch
to OFF and remove the battery.
ENGLISH 7