Indel B SAFE 10 SMART Mode D'emploi page 37

BATTERY REPLACEMENT
If a warning tone (beep) is sent from the safe after each opening and closing, the batteries need
to be replaced.
To do this remove the protection cover by unscrewing the screw and replace the exhausted
batteries with new ones.
WARNING
Make sure that the batteries in question are alkaline 1.5 Volt. Risk of explosion if battery is replaced
by an incorrect type. Dispose of used batteries according to the instructions.
WARNING
Batteries are delivered free of charge for the operating test and must be replaced in a short time.
EMERGENCY POWER SUPPLY
If batteries are not replaced before they are completely exhausted, it is possible to place a 9V
battery in the two contacts on the right of the display, to supply temporarily the Safe with power
and therefore be able to open it.
Screw
Batteries
35
Two contacts for 9V
emergency battery
Receiver
Cover