Berger MCX-35 Manuel D'utilisation page 23

WARNING!
Disconnect the cooling unit from the battery when the engine is not running so that the batte-
ry will not be discharged�
Connect the cooling unit to 230 V
Connect the 100 - 240 V AC connection cable to the 230 V AC mains supply�
• ON/OFF: Press the ON-OFF button (
switch off the device
• Press the " "(Up) button or the "
the " " button to increase the temperature or the "
• USB output for charging an electrical device�
• Press the "Settings button" to select the cooling mode of the appliance�
1� ECO (energy-saving mode)
2� MAX (maximum cooling mode)
The "MAX" mode is the selected setting by default�
• Press and hold the "Settings button" to adjust the battery protection level� As soon as the
currently set level (default M) flashes, you can change the level by briefly pressing the "Settings
button"�
If the device is connected to the car, we recommend setting the battery protection to level "H"�
The "M" and "L" levels are recommended when the device is connected to the backup battery�
Cars have different output voltages� Most cars cut the power supply as soon as the engine is
switched off� If your cooler is still running despite the motor being switched off, we recommend
setting the battery protection to level (H)� Otherwise, your car's battery may run down and there
may no longer be enough power to start the car�
When you take the cooling appliance out of operation:
- Press the Off button until the display goes out�
- Pull out the connector plug�
EXPLANATION OF THE OPERATING DISPLAY:
) to start the device� Press the ON-OFF button again to
"(Down) button to adjust the target temperature� Press
" button to decrease it�
GB
23