Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1
► 1. Blade edge 2. Cutting line
Adjust the edge fence until it comes in contact with the
side of the workpiece, then secure it by tightening the
screw.
1
► 1. Screw 2. Edge fence
When planing, move the tool with the edge fence flush
with the side of the workpiece. Otherwise uneven plan-
ing may result.
Maximum shiplapping (rabbeting) depth is 9 mm
(11/32").
You may wish to add to the length of the fence by
attaching an extra piece of wood. Convenient holes
are provided in the fence for this purpose, and also for
attaching an extension guide (optional accessory).
2
NOTE: The shape of the guide rule is differ from
country to country. In some country, the guide rule is
not included as a standard accessory.
Chamfering
2
To make a chamfering cut as shown in the figure, align
the "V" groove in the front base with the edge of the
workpiece and plane it.
MAINTENANCE
switched off and unplugged before attempting to
perform inspection or maintenance.
ner, alcohol or the like. Discoloration, deformation
or cracks may result.
8 ENGLISH
CAUTION:
Always be sure that the tool is
CAUTION:
Never use gasoline, benzine, thin-
Publicité
Table des Matières
