Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
How to Operate
1. Turn the thermostat knob fully in a clockwise direction to the maximum set-
ting.
2. Turn on the power by means of the thermostat switch on the side panel.
When the power is on, the power indicator will light up.
3.
Then turn on the heating function by means of the function selector
switch "
switch should be turned to the most high-grade "
or "
" the heating turns also the fan.
4. When the desired room temperature has been reached, the thermostat
knob should be turned slowly anti-clockwise until the thermostat is heard to
click off and the lights on the element switches are seen to go out. After this
the heater will keep the air temperature in the room at the set temperature
by switching on and off automatically.
IMPORTANT:
When in use, the radiator should always be kept vertical (supports
at the bottom, controls at the top). Any other position could be dangerous!
Cleaning
–
Always disconnect the heater from the mains supply before cleaning.
–
Clean the outside of the heater by wiping with a damp cloth and buff with
a dry cloth.
–
DO NOT use waxes or polishes as these may react with the heater and
cause.
Storing
1. Save the box for off season storage.
2. Clean the heater following the cleaning instructions above.
3. Remove the supports from the side panels.
4. Place the heater, and supports in the original box, and store in a cool and
dry place.
5. If you choose to store your heater fully assembled, be sure to cover it to
protect it from dust.
4
" on the side panel. For maximum heat output the selector
I
". If you select the ". ."
II
Instructions for use
Publicité
Table des Matières
