Publicité
Liens rapides
R2L 2
UK
Installation instructions
DE
Montageanleitung
CZ
Montážní návod
DK
Monteringsvejledning
EE
Paigaldusjuhend
TYPE : R2L2
R2L2 S
17
CLASS I
LED
1
96275070 01
FI
Asennusohje
FR
Notice de montage
HU
Szerelési útmutató
IT
Istuzioni di monttaggio
LT
Montavimo Instrukcijos
5
CLASS II
R2L2 S
R2L2 M
R2L2 M
S2 3 mm
24
(CL1)
IK08
IP66
LV
Instalacijas instrukcija
NO
Monteringsanvisning
PL
Instrukcja montazu
SE
Installationsanvisning
RU
The luminaire should be positioned so that
prolonged staring into the luminaire at a distance
closer than 2m is not expected
R2L2 S
R2L2 M
10 kg
14,5 kg
MAX
0,05 m
0,06 m
2
SC x
2
03/2024
Publicité
Manuels Connexes pour Thorn R2L2 S
Sommaire des Matières pour Thorn R2L2 S
- Page 1 Installationsanvisning Paigaldusjuhend Montavimo Instrukcijos TYPE : R2L2 The luminaire should be positioned so that prolonged staring into the luminaire at a distance closer than 2m is not expected R2L2 S R2L2 M S2 3 mm (CL1) CLASS II IK08 IP66...
- Page 2 PM, PN, ZU, ZUD 12 Nm SIDE 10° 0° 5° -5° 0° -10° -15° Versions with ADC 2.5 Nm 96275070 01 03/2024...
- Page 3 Class I with ADC Ø 6 - 12 mm 230V D1D2 DALI 50/60Hz DALI S2 3 mm 0.4 Nm Class II with ADC Ø 6 - 12 mm 230V D1D2 DALI 50/60Hz DALI BP Switch with ADC 100% 100% 100% Version with ADC 2.5 Nm 96275070 01...
- Page 4 Versions without ADC 2.5 Nm Ø 6 - 12 mm Class I without ADC 230V D1D2 DALI 50/60Hz DALI Ø 6 - 12 mm Class II without ADC 230V D1D2 DALI 50/60Hz DALI BP Switch without ADC 100% 100% 100% 96275070 01 03/2024...
- Page 5 Ø34 Ø42 14Nm max Ø49 Ø60 12Nm min Ø60 14Nm max R2L2 S R2L2 M Ø76 Ø 34 + reducer #96269015 (59005840) Ø 42 + reducer #96269015 (59005840) Ø 49 Ø 60 PM, PN, ZU, ZUD ZHAGA Version 96275070 01...
- Page 6 ZHAGA Version Tighten to the mechanical stop ZHAGA Version IP66 FRANCAIS SVERIGE ITALIANO -Remplacer toute protection fissurée. -Ersätta alla spräckta skyddsplåtar. -Sostituire sempre tutte le protezioni -Les luminaires classe II doivent être -Klass II armaturer måste installeras så danneggiate. installés de façon à ce que la partie att nakna metalldelar i armaturen inte -Gli apparecchi in classe II devono essere métallique ne soit pas en contact avec...