Publicité
INSTALLATION: Slip-Fitter Long Arm Mount
STEP 1: Loosen the fixing screw on the bracket with
a wrench to release the bracket holder. Remove the
screws from the junction cover of bracket holder.
STEP 3: Assemble bracket A and bracket B together
and fix with screw; adjust the angle needed and tighten
screw. Connect fixture's AC input wires with connectors.
L to L (Black), N to N (White), PE to PE (Green).
PHOTOCELL INSTALLATION, OPTION 1: Slip-Fitter Long Arm Mount
Punch out the photocell knock-out on the slip-fitter long arm bracket with a hammer. Follow STEPS 1 & 2 above. Install
photocell base and waterproof gasket on the slip-fitter long arm bracket, then tighten screws. Screw the photocell and
shorting cap into photocell base. Follow STEPS 3 & 4 above to complete installation.
NOTE: See page 10 for photocell wiring diagram.
PHOTOCELL INSTALLATION, OPTION 2: Slip-Fitter Long Arm Mount
Fix the photocell plate to the slip-fitter long arm bracket, unscrew with screwdriver to take off photocell plate. Follow STEPS
1 & 2 above. Install photocell base and waterproof gasket on the slip-fitter long arm bracket, then tighten screws. Screw
the photocell and shorting cap into photocell base. Follow STEPS 3 & 4 above to complete installation.
NOTE: See page 10 for photocell wiring diagram.
STEP 2: Pass fixture's AC input wires through bracket A
and assemble bracket A to the fixture body with screws.
Pass the pole wires through bracket B, then assemble
bracket B to pole. Pass pole wires from bracket B
through bracket A.
STEP 4: Tuck wires into junction box. Lock the cover
back to junction box.
7
Publicité
