Publicité
Les langues disponibles
Les langues disponibles
NOTE:
Use a pin to press and hold the reset button for about 15 seconds to restore factory
default settings. Perform this operation within 10 minutes after the device is powered on or the
reset will fail otherwise.
Installation Requirements
Precautions
Make sure the working temperature is maintained at -30°C~60°C, and the relative humidity is ≤95%.
Keep the camera from excessive pressure, vibration, moisture, dust, and intensive electromagnetic
radiation.
Use a power adapter or a PoE device that meets the requirements. Otherwise, the device may be
damaged.
Make sure the length of the power cable between the power adapter and the camera is not too long,
otherwise the camera might work abnormally because of the lowered voltage. If necessary, lengthen
the cable between the power adapter and the mains.
Do not overbend the cables during the installation, otherwise, poor cable contact may cause
malfunction.
Do not hold the tail cable by hand for weight bearing. Otherwise, the cable connector of the camera
could be loosened.
When connecting to an external interface, use an existing connection terminal, and ensure that the
cable terminal (latch or clamp) is in good condition and properly fastened.
Ensure that the cable is not tense during mounting, with a proper margin reserved to avoid poor port
contact or loosening caused by shock or shake.
Do not remove the protective lm on the device until mounting is nished. Remove it before powering
on the device.
3
Publicité
