Publicité
Les langues disponibles
Les langues disponibles
11
Water Supply Lines are not included. Please
consult manufacturer and/or its instructions
for the correct method of installation of supply
lines and fittings.
CAUTION: Incorrect application of supply lines and
fittings may result in the failure or leak of the supply
lines and fittings.
B
11C
11C
1" Max.
(26 mm)
11D
11A
11B
HOT
C
11E
11F
11B
11 WATER SUPPLY CONNECTIONS
A.Thread inlet connectors (11A) into Water Supply Lines (11B).
B.Remove Protective Cap (11F). Gently separate HOT and COLD Faucet Inlets (11C),
approximately 1 in. (26 mm) apart. Connect Water Supply Lines (11B) onto Faucet Inlets
(11C). Hot Water supply goes to hot inlet fitting indicated by red tag (11D).
C.Insert Clip (11E) into Inlet Connector Holes (11F) to secure water supply lines, as shown.
WARNING: Do not twist Faucet Inlets.
A
11A
11B
11C
11A
11F
COLD
11B
11E
11A
11B
12
12 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below the sink
13
13 FLUSHING
By rotating the Lever Handle (13A) away from the Faucet Body (13B), the valve will be
activated allowing water to flow. The water flow will increase by continuing to rotate the
Lever Handle (13A). Run water for one minute. Repeat in hot and cold positions.
14
14B
14A
14 ATTACH SPRAY HEAD
Attach Spray Head (14A) to the Hose (14B) by turning Spray Head (14A) clockwise.
Caution: do not over tighten sprya head and hose.
4
OPEN
13A
13B
13A
Publicité
