Publicité
Les langues disponibles
Les langues disponibles
Thank you for purchasing this Pfister product. All Pfister products are carefully engineered, and factory tested to provide long trouble-free use under normal conditions. This
product is easy to install using basic tools and our easy to follow illustrated instructions. If you have any questions regarding this product, call 1-800-340-7608.
BEFORE PROCEEDING
WARNING Read all the instructions completely before proceeding. Pfister recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and building codes.
1
1 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually
found under the sink or near the water meter. If you are replacing an existing
faucet, remove the old faucet from the sink and clean the sink surface thoroughly.
2
2 TOOLS RECOMMENDED
.
.
Plumber's Putty
Pliers
.
.
Flashlight
Cloth
Installation may require new supply lines and/or shut-off valves or other additional tools.
3
B
M
N
L
C
K
3 CHECKING THE CONTENTS OF THE BOX
Upon opening the box, check to ensure that all of the following items are included:
A Faucet Body
B Spray Head (Detached)
D Mounting Ring
E Putty Ring
G Putty Plate
H Wing Nuts (2x)
K Locknut
L Quick Connector
N Installation Tool
P Spout Washer
If any of these items are missing, please contact Pfister
1–800–340–7608 or visit www.international.pfisterfaucets.com.
.
Asdjustable Wrench
A
D
E
F
G
H
P
J
H
C Hose
F Deckplate
J Metal Washer
M Inlet Connectors (2X)
Consumer Services at
TM
4
These instructions cover two different
installation procedures.
Option 1:
3 Hole With Deckplate
Installation
Go To Step 5
Go To Step 5
3 HOLE INSTALLATION
5
5A
BOTTOM GROOVE
5 INSTALLING DECKPLATE
Ensure that Plastic Putty Plate ( 5A ) is pressed on to Deckplate ( 5B ). Place a bead of
plumber's putty in the bottom groove along the outer edge of the Putty Plate ( 5A ). Install
Deckplate ( 5B ) over the three holes in your sink.
6
6A
6 SECURING DECKPLATE
From underneath sink, hand tighten Wing Nuts ( 6A ). NOTE: do not over-tighten wing nuts.
Remove any excess putty from around the outside edge of Putty Plate ( 6B ).
2
Option 2:
1 Hole With Single Post
Installation
Go To Step 7
Go To Step 7
5B
6B
6A
Go To Step 8
Go To Step 8
STOP
STOP
Publicité
