Signature Design by Ashley EF19-30-2A Mode D'emploi page 7

OPERATIONS AND FEATURES
Using the Remote Control
Power
This will turn the unit ON and
OFF. When it is turn OFF,
fan will continue to run after
turning off the heating function
to cool and protect the unit from
overheating up to a period of 3
. When the unit is
minutes
turned back ON, the system will
recall the last heat setting used.
Store flame and Heating setting.
Adjust Brightness
This allows you to raise or lower
the level of flame brightness.
Note: when the unit is turned off
that the LOGS completely die out
for 3 seconds.
Timer
This allows you to set the fireplace
to automatically shut OFF after
the amount of time displayed on
the screen, the timer can be set
from 10 minutes to 9 hours, the
display shows 10, 20, 30, 40, 50,
1H, 2H, 3H, 4H, 5H, 6H, 7H, 8H,
9H. Do not operate fireplace
while unattended.
Using the Control Panel
Timer/Dynamic Embers
This will allow you to set
the automatic shutoff on
the fireplace. Dynamic
Embers will work on the
unit hold 5 seconds when
beeps press again. To
stop embers press timer
button then hold for 5
seconds.
EF19-30-2A
MODEL#:
The
Adjust Temperature
This allows programming of
the thermostat. The
fireplace can be used
without the heater if
desired. Simply cycle
through the function until
no temperature is
displayed. Press and hold
the button for five seconds
Ambient Light
to switch temperature
readout from
This will turn the ambient
light above logs ON/OFF. ℉
(Celsius) and back.
Adjust Brightness
This function will cycle
through the five different
(Fahrenheit) and
℃
levels of flame brightness.
Ambient Light
This will turn the ambient
light above logs ON/OFF.
Adjust Temperature
This allows programming of the
thermostat. The fireplace can be
used without the heater if
desired. Simply cycle through the
function until no temperature is
displayed. Press and hold the
down arrow for five seconds to
switch temperature readout from
(Fahrenheit) and (Celsius)
℉ ℃
and back. Must be in Heat mode.
Dynamic Embers
This function will make the
embers of the fire automatically
glow dimmer and brighter
creating a more realistic fire
effect.
Power
This will turn the unit
ON and OFF. When it is
turn ON, the machine
will red heating slowly.
When it is turn OFF, t
fan will continue to run
after turning off the
heating function to cool
and protect the unit from
overheating up to a
period of 3 minutes
When the unit is turned
back ON, the system
will load default factory
settings.
he
.
Page 8 of 12