ENERGY SISTEM ENERGY Aquatic 2 Série Manuel De L'utilisateur page 19

BATTERY
≥
Your MP3 Energy has an integrated rechargeable Li-Ion battery. It comes fully charged
from factory, but it is recommended to perform a full recharge before the first use.
Recharge the battery connecting the player to a computer using the bundled USB 2.0
cable. Optionally you can recharge the battery with an AC/DC adaptor with a type
mini-B 5 pin USB connector.
Important: Always connect first the USB cable to the earphones connector, and then
the USB connector to the computer or USB charger in order to avoid shortcircuits
chances. It's also advisable to connect the player while powered off.
During the charge, the PLAY button LED light will blink. Charging time is between 2 and
3 hours. To keep the battery in good conditions, we recommend not leaving the player
charging for more than 8 hours. Your MP3 Energy optimizes battery usage but turning
off the player after 5 minutes idle.
POWER ON / OFF
≥
To power on your MP3 Energy press PLAY for a few seconds until the LED light turns on.
Note: When powering on, the device performs a memory check. The power on time
depends on the total amount of memory and the current ammount of used memory.
Press PLAY for a few seconds to power off the device while it is on. At that moment, the
device will save your current playback position.
Note: If you power off the device directly with the reset button, your last changes
regarding playback song and position will be lost.
19