Switching The Alarm Function On/Off; Waking Up - ADE CK 1927 Mode D'emploi

Alarm
8. Use the or
span between two alarms). If you select "OFF", the snooze function is switched off.
9. Press .
10. Proceed as described to make the same settings for "AL 2". If you do not want to set
a second alarm time, simply press
again.

Switching the alarm function on/off

1. Press the button once or twice to select the respective alarm ("AL1" or "AL2").
2. Use to set the display to "ON". The display shows e.g.
selected setting). The alarm function is activated.
To disable the alarm function, proceed as described and then use
the display to "OFF" with the alarm function enabled.

Waking up

At the set time, you will be woken by an alarm signal, which will become more intense
as the waking time increases.
Interrupting the alarm for 24 hours
− Keep the
interrupt the alarm.
After 24 hours, the alarm will be triggered again.
Auto-stop function
If you do not press a button, the alarm switches off automatically after 2 minutes. After
24 hours, the alarm will be triggered again.
Repeat alarm (snooze function)
− Briefly tap the
The alarm signal will be muted and the bell symbol
the display.
The device will switch on again and wake you up again according to the setting made
(default setting: 5 minutes). This procedure can be repeated multiple times.
To disable the snooze function, press any button on the side or keep
pressed for a few seconds during the snooze phase. The alarm is then only
triggered again in 24 hours.
26
button to set the desired time span for the snooze function (time
sensor field pressed for a few seconds or press any button to
sensor field once when the alarm signal sounds.
repeatedly until the normal display is shown
CK 1927 XL radio-controlled wall clock
(depending on the
or and will flash on
to set