GE RAK149F2 Manuel Du Propriétaire Et Instructions D'installation page 6

INSTALLATION INSTRUCTIONS
TO INSTALL THERMOSTAT
IMPORTANT:
must conform to local and national building and
electrical codes and ordinances.
NOTE: Mount the thermostat about five feet above
the floor. Do not mount the thermostat on an outside
wall, in direct sunlight, behind a door or in an area
affected by a vent or duct.
1. Turn off power to the heating and cooling system
by removing the fuse or switching off the
appropriate circuit breaker.
2. Move the Function switch on the thermostat
to Off.
3. Remove the cover by inserting and twisting a
coin or screwdriver in the slots on the top of the
thermostat.
4. Put thermostat base against the wall where you
plan to mount it. Make sure wires will feed through
the wire opening in the base of the thermostat.
5. With the base level, mark the placement of the
mounting holes.
6. Set thermostat base and cover away from working
area.
7.
you have marked for mounting.
8. Use a hammer to tap supplied anchors in
mounting holes.
9. Align thermostat base with mounting holes and
feed the control wires through the wire opening.
Thermostat installation
6