Publicité
Les langues disponibles
Les langues disponibles
Check location where washer will be
installed. Proper installation is your
responsibility. Make sure you have
everything necessary for correct
installation.
Do Not store or operate washer below
32°F (0°C) (some water may remain in
washer).
Untape and
open washer
lid. Remove
packages and
hoses from
washer.
No. T20 TORX
®†
screws
Front access to the pump area is
available by removing 2 No. T20
®†
Torx
screws and then removing
the front panel.
IMPORTANT: Observe all governing
codes and ordinances.
PAGE 3
Single washer
installations require
Grounded
12-inch (300 mm)
electrical outlet
minimum risers to
is required. See
provide an air
Electrical
cushion and avoid
requirements.
noise and damage
to valves.
Level floor: Maximum slope
under washer — 1 inch (25 mm).
A floor drain should be
provided under the bulkhead.
Prefabricated bulkheads with
electrical outlets, water supply
lines and drain facilities should
be used only where local
codes permit.
Hot and cold water faucets: Must be
within 4 feet (1.2 meters) of the back
of the washer and provide water
pressure 10 - 100 PSI (69-690 kPa). A
pressure reduction valve should be
used in the supply line where inlet
pressure entering the building
exceeds 100 PSI (690 kPa) to avoid
damage to the washer mixing valve.
Water heater: Set to
deliver 120°F (49°C)
water to the washer.
Standpipe drain system: Needs a
two-inch (50 mm) minimum carry-
away capacity of 17 gallons (64.4
liters) per minute. Top of standpipe
must be at least 39 inches (990 mm)
high and no higher than 72 inches
(1.83 m) from bottom of washer.
IMPORTANT: Floor must be sturdy
enough to support loaded washer
weight of 315 pounds (143 Kg).
†® TORX is a registered trademark of Acument
Intellectual Properties, LLC.
Publicité
