audiophony SLI1000.2 Guide De L'utilisateur page 14

English
4-6 - 100V bridged mode
CHANNEL A
LINK A INPUT A
A signal is injected into INPUT A.
This signal is amplified by adding the two power channels A and B.
Level control is via the VOL A potentiometer, with channel B deactivated.
The bridge output is available on channel A (pins + on 1+ / - on 2+).
Dangerous voltage
The speaker lines should be
connected to the amplifier last.
Switch on the amplifier when the
installation has been completed and
checked.
4-7 - MUTE mode
The input signals are muted.
Page 14
CHANNEL B SUB-X-OVER FREQ.
120 170 120 170
70 230 70 230
50Hz 250Hz 50Hz 250Hz
CHA CHB
INPUT B LINK B
Audio source
MODE OUT A OUT B
CH B
CH A
1+ 1-
1+ 1-
CH B
2+ 2-
BRIDGE
1+ 2+
BRIDGE
1+ 2+
Caution: The sum of the powers of all the speakers
connected must not exceed the maximum power
of the amplifier.
SLI1000.2 - Class D stereo amplifier
MADE IN CHINA
DISTRIBUTED
BY HITMUSIC S.A.S
100 V loudspeakers