Publicité
• Do not remove the jug with the food until the blade is totally
stopped and the appliance has been switched off.
• Make sure neither the appliance nor the cable are in direct
contact with hot surfaces or objects.
• Always place it on a flat surface.
• Always disconnect it from the mains when you do not use it and
before assembling / disassembling or when cleaning.
• Take all necessary precautions while handling the blade, as it is
very sharp.
• High temperature contrasts could be the cause of broken jars,
avoid them to prolong the life of your glass jar.
• The cleaning and maintenance done by users, can not be done by
children.
• If the cable were to deteriorate it must be changed by an
Authorised Service Centre.
INSTRUCTION OF USE
• At the factory, the threaded base (6) and the blade (7) are placed in its place over the main body.
• Place the jug (3) over the base / blade set and screw firmly until the end. Once the appliance is plugged to the
main, the blue ring surrounding the speed selector (5) will light up.
• Before the first use, you can follow the maintenance and cleaning instructions.
• Pour the food in the jug and place the lid on it. Make sure the blender is perfectly closed and maintain always
held while in use.
• Plug the appliance into the mains.
• Turn the speed selector (5) clockwise to the desired position (1 or 2). The blender will begin to work maintaining
the selected speed.
• It is advisable to begin at the lowest speed of the blender (position 1) to later raise the highest speed (position 2)
if necessary. However, and depending on the texture of the food, you may use the highest speed from the
beginning.
• The "PULSE" position of the speed selector gives you the option to use the blender intermittently, as it will only
work while you keep the selector (5) turned to that position, and it will stop when it is released.
• This position is ideal for crushing ice. Repeatedly hold and release the selector (5) in short periods of approximately
2 seconds to get crushed ice. For it, we suggest to use little ice cubes, or you can bitted them before put them on
the blender, to avoid the "igloo" effect. This means that the crushed ice get adhered to the blender walls, and it
impede that the other ice cubes arrive to the base to be crushed.
• You may add ingredients to the jug while in use without open the lid. To do so, remove the stopper (1). Add the
ingredients into the jug and place again the stopper.
• Once you have finished, set the speed selector to its " 0" position and wait for the blade to stop turning completely
before removing the jug.
MAINTENANCE AND CLEANING
• Before you proceed to cleaning, make sure the appliance is unplugged from the mains.
• Unscrew the jug to remove the base / blade set (6 - 7), handle carefully with the blade.
• The jug, the lid and the stopper may be cleaned with soap and water, never in the dish-washer, taking care to
rinse and dry them carefully afterwards.
01 manual jata BT604N + checo.indd 11
11
05/03/18 16:51
Publicité
