Publicité
Les langues disponibles
Les langues disponibles
8
Mounting remote controller holder
Direct the transmitter of the remote controller toward
the signal receiving unit.
When the signal is normally received, "Pi" sound is
heard once.
("Pi, pi" sounds are heard only when the operation has
started.)
The standard distance for signal reception is
approximately 26'3" (8 m) vertically against the signal
receiving unit.
The distance differs a little according to the capacity of
the battery or other factor.
Be careful there is not something to block the signal
between the signal receiving unit and the remote
controller.
Do not put the remote controller on the place exposed
to the direct sunlight or air from the air conditioner or
near the stove, etc.
Do not drop, throw, or clean with water the remote
controller.
The signal may not be accepted in a room where the
electronic instantaneous-ON type, inverter type
fluorescent light, or equipment emitting infrared rays
(Electronic whiteboard etc.) is set. For details, contact
the shop which you purchased the air conditioner.
13-EN
1130615205_EN-ES-FR.indb 13
1130615205_EN-ES-FR.indb 13
To use the remote controller
setting to wall
Check a signal is received correctly by pushing the
START/STOP (
) button at the position to be fixed.
Flat head
wood
screw
Setting method of remote
controller
– 13 –
Remote control holder
9/8/2565 BE 15:38
9/8/2565 BE 15:38
Publicité
