Denon Professional Envoi Receiver 2 Guide D'utilisation page 6

Wireless Mic Setup
To use a wireless mic, follow these setup steps:
1. Ensure 2 new AA alkaline batteries are installed in the Envoi HL Transmitter.
2. Pair the wireless mic to the Envoi receiver.
a. Turn on the Envoi HL Transmitter and Envoi receiver.
b. Select the UHF channel on the receiver that you want to use with the
best reception.
c. Place the IR sensor (found above the battery compartment) near the
receiver's IR LED and press the ASC button once on the receiver. Wait
for about 3 seconds until the IR LED stops flashing. When it finds an
interference-free channel the RF LED will illuminate on the receiver
showing the mic is matched to that channel.
3. To connect the mic to Envoi HL Transmitter, insert the connector into the input
and screw in the connector clockwise to lock it. To unplug, reverse this
process.
• If
using a headset
(76 mm) from your mouth, but away from the wind path to avoid breath
and "pop" sounds.
• If using a lavalier mic, clip this on your shirt at chest-height, up to 6"
(152 mm) away from your mouth.
4. Adjust the Power-Vol knob clockwise on Envoi Receiver 2.
5. As you speak, watch the AF indicator on the receiver to make sure a signal is
being received. The Gain Selector on the Envoi HL Transmitter can be
adjusted for more or less output signal.
6
mic, position the mic about 3"