Sanus VML10 Manuel D'instructions page 6

3 Mount the Wall Plate
Wood Stud Mounting
3-1
Locate studs
3-2
Mark the wall
3-3
Drill pilot holes
3-4
Tighten lag bolts
[03]
6
≤ 16 mm
(5/8 in.)
[01]
[04]
For assistance in determining wall plate location, see Height Finder at
sanus.com.
The VML10 is designed for use in either single or dual stud walls.
Locate a stud or studs. Verify the center of the stud(s) using an awl or
edge to edge stud fi nder.
CAUTION:
damage!

Drywall covering the wall must not exceed 16 mm (5/8 in.).

Minimum wood stud size: common 51 x 102 mm (2 x 4 in.)
nominal 38 x 89 mm (1½ x 3½ in.).
Level the wall plate [01] and mark the hole locations.
OR
[01]
CAUTION:
holes MUST be drilled to a depth of 70 mm (2¾ in.), using a 5mm
(3/16 in.) diameter drill bit.
OR
70mm
(2¾ in.)
Using a drill and the allen driver bit [03] tighten lag bolts [04] only
until they are pulled fi rmly against the wall plate.
CAUTION:

DO NOT over-tighten the lag bolts [04].

Tighten the lag bolts only until they are pulled fi rmly against the
[01]
wall plate [01].
OR
[04]
Avoid potential personal injuries and property
41 cm
(16 in.)
Avoid potential injuries or property damage! Pilot
Avoid potential injuries or property damage!
[01]
[03]
5 mm
(3/16 in.)
6901-002029 10