Changhong LED32D2200DS Mode D'emploi page 14

Basic Operation
Turning on and off the TV
• Turn on the TV
Connect the power cable. If TV has a power switch, turn it on firstly. Press the
button on remote control can turn on TV from standby mode.
• Turn off the TV
Press the button on the remote control to enter standby mode.
Do not leave your set in standby mode for long periods of time. It is best to unplug the
set from the mains and aerial.
• No signal
There is No Signal menu on screen when there is no input signal. In ATV/DTV mode,
if there is no signal in 5 minutes, the TV will turn off automatically. In PC mode, the TV
set will automatically turn off in 60 seconds if no input signals. When VGA cable is
connected, the TV turns on automatically.
Programme Selection
• Using the CH+/CH- on the panel of TV or on the remote control
Press CH+ to increase channel number.
Press CH- to decrease channel number.
• Using 0- 9 digital buttons.
You can select the channel number by pressing 0 to 9. (In DTV/ATV mode)
• Example
To select - channel (e.g. Channel 5): Press 5.
To select -- channel (e.g. Channel 20): Press 2 and 0 in a short time.
Volume adjustment
• Press the VOL+/- button to adjust the volume.
• If you want to switch the sound OFF, press the
• You can release mute by pressing the
Changing the Input Source
You can select the input source by pressing the SOURCE button on the remote control.
Press the▲/▼button to cycle through the input source, and press the ENTER button to
confirm your choice.
.
or increase the volume.
11