Publicité
Les langues disponibles
Les langues disponibles
Wall mounting your baby monitor
Tools required for mounting (not included): Phillips
head screwdriver, hammer, drill with 3/16" size bit,
and pencil.
Before wall mounting, ensure optimal placement of the
baby monitor by viewing the monitor within the app
or on the parent display. The following instructions are
for securely mounting to a drywall surface.
1. Examine the room and determine the optimal placement on the wall. Mark
this location with a pencil. IMPORTANT: Ensure that the
baby monitor is at least 3 ft (0.9 m) away from the crib.
2. Place the included wall mount onto the wall at the marked
location, ensuring the arrow is pointing upwards. Using a
pencil, make a mark through the two screw holes. Put the
wall mount to the side for later use.
3. Using a 3/16" drill bit, drill a hole 1.0" (2.54 cm) deep on the
pencil marks. DO NOT drill through the wall mount holes.
4. Insert drywall anchor into the hole. If necessary, lightly
tap with a hammer until the drywall anchor is flush with
the wall surface. Note: If mounting to a wall stud, drywall
anchors are not required.
5. Align the holes of the wall mount with the drywall
anchors and using a screwdriver, hand tighten a screw into each of the
drywall anchors. DO NOT overtighten.
6
6. Locate the hole underneath the base of the
3'
(0.9 m)
monitor and place it on the wall mount.
7. Applying light pressure to the base, twist the
monitor counterclockwise until the Maxi-Cosi logo
is facing down. DO NOT pull on the monitor head.
a. To remove the monitor from the wall, push up on the base until it
releases from the mount. NEVER leave the monitor hanging on the
wall mount without clicking in place.
8. Before proceeding to the next step. Ensure that the viewing angle is to
your liking by verifying the app. Rotate and tilt the monitor as needed.
9. Wall clips: Use the included wall clips to secure the
cord at least 3 ft (0.9 m) away from the crib:
a. Repeat steps 3 and 4 to install the wall anchors
into the drywall. Ensure that wall anchors are
placed 2 ft (0.61m) apart.
b. Place cord into the wall clips, leaving a little slack.
c. Align wall clip hole to wall anchor. Close the top cover
to secure the cord in place.
d. Ensure holes of the provided wall clips are aligned
with the wall anchors and insert provided screw.
Using a screwdriver, hand tighten a screw into each
wall clip.
7
Publicité
