Rothenberger Industrial 1500003730 Mode D'emploi page 12

Before Use
Before Use
Checking the product and scope
of delivery
• Check whether the product or the accessories
are damaged.
• Do not use the product if it is damaged or parts
are missing. Contact the manufacturer via the
service centre listed on the back of this user
manual.
Inserting / removing the gas
canister (Fig 1,2,3.5)
WARNING!
Before removing the gas canister, make
sure that the burner is
the gas canister may be hot.
CAUTION!
Change the gas canister only outdoors
and away from others.
• Turn the regulator with piezo ignition
position .
• Open the canister slot cover
• Slide the canister locking lever
and remove the gas canister already inserted
from the canister slot.
• Check the valve seal
new gas canister into the canister slot.
• Insert the gas canister into the canister holder
4
such that the pin of the canister valve can
be inserted into the appliance valve.
• Make sure that the lock in the canister slot fits
into the groove A
Fig. 2).
• Close the canister slot cover.
• Push the canister locking lever down till it locks
in the lower position.
• Check if the stove is tightly connected to the
gas canister. If you smell gas or hear a 'hissing'
noise, remove the gas canister and stop using
the stove.
14
1500003730_Anleitung_Kern.indb 14 1500003730_Anleitung_Kern.indb 14
off. Caution,
3
6 to the
3 .
7
upwards
5 before inserting a
on the gas canister (see
• In case gas is leaking from your product (smell
of gas), turn the gas supply off immediately by
sliding the canister locking lever upwards. Then
take the stove outdoors immediately to a place
with good air circulation without any ignition
sources, where the leak can be detected and
stopped.
- Take the appliance outdoors before checking
for leaks.
- Never check for leaks using a flame; always
use a soapy solution or a leak detection spray!
Usage
CAUTION!
Accessible parts may be very hot. Keep
small children away from the stove.
Tuning the stove on / off (Fig. 4)
Ignition
• Turn the regulator with piezo ignition
position .
• Slightly rotate the regulator with piezo ignition
beyond the position .
- You will hear a click.
- Check if the burner is on.
procedure if necessary.
- Remember that the flame may be hardly
visible in bright sunlight.
Extinguishing
• Turn the regulator with piezo ignition to the
position .
6 to the
8 Repeat the
31.03.2022 08:52:41 31.03.2022 08:52:41