LCG MixLaser III Manuel page 21

MixLaser III Manuel de l'utilisateur /User Manual
15 Sound ON
16 Sound OFF
17 Speed-
18 Speed+
19 Speed
DMX-512 connection
3-Pins DMX Out
(Female)
DMX
Each fixture must set a specific starting address. When receiving signal transmission, fixture will
receive channel control signals which from the starting address.
According to different requirements or easy to use, the user can set many value fixtures to the same
address, also can set up a separate address for every device.
If you set the same address,all the devices will receive from DMX channels signal. All connecting
fixtures are jointly controlled, controller can't separate control a device.
If you set a different address, each device will be separate from its particular set the starting address
and begin accepting DMX512 control signal, so that more convenient separate control one device.
Using this method must be based on channel quantity of device to determine a starting address.
This light has 10 channels. When you use 10CH, you should set the starting address of the first unit
to 1, the second unit to 11(10+1), the third unit to 21 (11+10), and so on.
10CH for example
（address 001）
First
Sound mode open，Show 1-5 in this mode show 5 different effect
Sound mode closed, show 1-5 in this mode show Auto effect
Speed down
Speed up
Speed set as default data
3-Pins DMX In
(Male)
1 Earth
address setting
（address 011）
Second
2 DMX-
Third
（address021）
- 20 -
3 DMX+