LCG MixLaser III Manuel page 16

MixLaser III Manuel de l'utilisateur /User Manual
Even very small amounts of laser beam light are potentially hazardous even at long distances.
Laser eye injuries can be sustained faster than you can blink.
Do not think that because this laser splits the laser beam into hundreds of beams and that the laser
beam is scanned out in high speed, that an individual laser beam is safe for eye exposure. This
laser uses dozens of milliwatts of laser power (Class 3B levels internally) before it splits into
multiple beams (Class 3A levels). Many of the individual beams are potentially hazardous to the
eyes.
Do not that because the laser light is moving, it is safe. This is not true. Nor, do the laser beams
always move. Since eye injuries can occur instantly, it is critical to prevent even the smallest
possibility of any direct eye exposure. In the laser safety regulation, it is not legal to aim Class 3A
lasers in areas which people can get exposed. This is true even if it is aimed below people's faces,
such as on a dance floor.
Do not operate the laser without first reading and understanding all safety and technical data
in this manual.
Always set up and install all laser effects so that all laser light is at least 3 meters (9.8 feet) above the
floor on which people can stand.
After setting up, and before public use, test laser to ensure proper function. Do not use if any defect
is detected. Do not use if laser emits only one or two laser beams rather than dozens/hundreds, as
this could indicate damage to the diffraction grating optic, and could allow emission of higher laser
levels above Class 3B.
Do not point lasers at people or animals. Never look into the laser aperture or laser beams.
Do not point lasers in areas in which people can potentially get exposed, such as uncontrolled
balconies, etc.
Do not point lasers at highly reflective surfaces, such as windows, mirrors and shiny metal. Even
laser reflections can be hazardous.
Never point a laser at aircraft, this is a federal offense.
Never point un-terminated laser beams into the sky.
Do not expose the output optic (aperture) to cleaning chemicals.
Do not use laser if the laser appears to be emitting only one or two beams.
Do not use the laser if the housing is damaged, the housing is open, or if the optics appear
damaged in any way.
Never open the laser housing. The high laser power levels inside of the protective housing can start
fires, burn skin and will cause instant eye injury.
Never leave this device running unattended.
The operation of a class 3B laser show is only allowed if the show is controlled by a skilled and
well- trained operator, familiar with the data included in this manual.
The legal requirements for using laser entertainment products vary from country to country. The
user is responsible for the legal requirements at the location/country of use.
Always use proper lighting safety cables when hanging lights and effects overhead.
Safety Instructions
 Please open and check whether break or not for transport once receive this fixture, if yes, not use
it and contact dealer or manufacture as soon as possible.
 The Max applicable temperature for the light is 40°C. Do not use the light under or above the
temperature. ta=40℃
 The fixture is applicable for many occasions,
overheating or dusty environment. To prevent the fixture from the chemical liquid .
 User must be careful of fire, heat, electric and fall-off that make heavy or fatal injury. Please read
this user manual carefully before power on and installation, following safety and operation
instruction in it. If still have any questions, please contact dealer or manufacture.
it should keep clean, and avoid long use in
- 15 -