SMART SML6 Mode D'emploi page 3

Charging and active
A: Connect the SML6 charging cable to a 5V-1A
adapter and plug it in. Charging the device for
2-3 hours.
B: Align the magnetic suction tube with the metal
plate on the bottom of the device's outer shell.
The magnet will automatically attach to the
positive and negative poles and charge the
device.Ensure that the charging contacts are
clean and free from dirt and debris.
NOTE: If the device is not used for a long time,
the battery may enter a 0 voltage protection
state. Charge the device for at least 15 minutes
to accumulate enough charge to start the watch
at a sufficient level. It is recommended to charge
the device once a month. Keep the device fully
charged and power off when not in use.
1
EN