Goodwe HCA Serie Manuel D'utilisation page 3

01 Safety Precaution
General Disclaimer
• The information in this user manual is subject to change due to product updates or other
reasons. This guide cannot replace the product labels or the safety precautions in the user
manual unless otherwise specified. All descriptions in the manual are for guidance only.
• Before installations, read through the quick installation guide. For additional information,
please see the user manual.
• All operations should be performed by trained and knowledgeable technicians who are
familiar with local standards and safety regulations.
• Check the deliverables for correct model, complete contents, and intact appearance. Contact
after sales service if any damage is found or any component is missing.
• Use insulating tools and wear personal protective equipment (PPE) when operating the
equipment to ensure personal safety. Wear anti-static gloves, cloths, and wrist strips when
touching electron devices to protect the equipment from damage.
• Strictly follow the installation, operation, and configuration instructions in this guide and
relative user manual. The manufacturer shall not be liable for equipment damage or personal
injury if you do not follow the instructions. For more warranty details, please visit:
en.goodwe.com/warranty.
Safety Disclaimer
Instructions during Installation
1. Do not dismantle the charger modules personally. Do not extend the charging cable.
Otherwise, it may cause Ingress Protection Rating derating or electric danger.
2. The equipment supports charging Electric Vehicle (EV hereinafter) only. Do not charge other
devices.
3. Wrap the charging cable around the charger after using. Water or other debris shall not enter
into the charging connector.
4. The charger and cables shall not be over bended, squeezed or entangled. Otherwise, it may
cause damage to the equipment.
5. Disconnect the charger and its upstream switches before installation, maintenance and other
operations.
6. It is strictly forbidden to touch t the charging connector when the charger is live.
7. Check whether the cover and appearance of the charger are normal regularly.
8. Use clean and dry cloth to wipe the charger and its modules.
9. All labels and warning marks should be visible after the installation. Do not cover, scrawl, or
damage any label on the equipment.
10. Warning labels on the Charger are as follows:
HIGH VOLTAGE HAZARD
High voltage exists during
the charger's running.
Disconnect all incoming
power and turn off the
product before working on it.
Read through the user
manual before any
operations.
Delay discharge. Wait 5 minutes
after power off until the
components are completely
discharged.
Potential risks exist. Wear
proper PPE before any
operations.
1
EN
EN
https://