ChefLine CHVP355C Manuel D'utilisation page 11

Troubleshooting
Fault
The appliance is not
working
The appliance turns
on, but the
temperature
is too high/ low
The appliance is
unusually loud
The appliance is
leaking water
GB
Potential Failure
The unit is not switched on
Plug and/ or lead are damaged
Fuse in the plug has blown
Power supply
Too much ice on the evaporator
Condenser blocked with dust
Doors are not shut properly
Appliance is located near a heat
source or air flow to the condenser is
being interrupted
Ambient temperature is too high
Unsuitable foodstuffs are being
stored in the appliance
Appliance is overloaded
Loose nut/ screw
The appliance has not been installed
in a level or stable position
The appliance is not properly leveled
The discharge outlet is blocked
Movement of water to the drain is
obstructed
The water container is damaged
The drip tray is overflowing
11
Problem solving action
Check the unit is plugged in correctly and
switched on
Call your agent or qualified technician
Replace the fuse (UK Plug)
Check power supply
Defrost the appliance
Call your agent or qualified technician
Check doors are shut and seals are not
damaged
Move the refrigerator to a more suitable
location
Increase ventilation or move appliance to
a cooler position
Remove any excessive hot foodstuffs or
blockages to the fan
Reduce the amount of food stored in the
appliance
Check and tighten all nuts and screws
Check installation position and change if
necessary
Adjust the screw feet to level the
appliance (if applicable)
Clear the discharge outlet
Clear the floor of the appliance (if
applicable)
Call your agent or qualified Technician
Empty the drip tray (if applicable)
P2M032STD-Ver1.0