Publicité
Les langues disponibles
Les langues disponibles
7.
Install CE housing over the locator pins and install CE attaching screws, assuring the square fiber washer is properly aligned with
the anti-turn feature on the CE housing.
8.
On models with OCP, assure the OCP connector is seated properly into the housing and torque the CE attaching screws to 4.5-6.8
Nm (40-60 lb in).
9.
First insert the small round fiber insulator and then the rubber bushing over the ground stud into the hole on the CE
housing. Installing the rubber bushing prior to installing the CE housing can pinch the bushing and destroy its sealing
capabilities.
10. Install the large round fiber washer and the remaining hardware in the same order the parts were removed. Torque the
large nut on ground stud to 27.0-33.8 Nm (20-25 lb ft).
11. Install clip on OCP connector, if applicable.
12.
DANGER!!!
Do not reconnect solenoid motor connector strap to field terminal before adjusting the pinion clearance.
NOTICE! After repair and reassembly it is necessary, before installation on the engine, to check and adjust pinion clearance. It
is recommended the solenoid replacement instruction sheet, be obtained from our website, www.delcoremy.com.
13. Reinstall starter and connect cables and other leads, as removed.
14. Reconnect the negative (-) cable at the battery.
15.
Technical support: USA 800 372 0222, Mexico 01 800 000 7378, Brazil 0800 703 3526, South America 55 11 3183
0384 or visit delcoremy.com
NOTICE
- Only licensed Delco Remy products and component parts should be used, and the use of other parts or modifications not
approved by PHINIA will void all applicable warranties. The failure to carefully follow these Instructions, set forth herein, will void all
applicable warranties. DELCO REMY is a registered trademark of General Motors LLC, licensed to PHINIA Technologies Inc.
© 2023 PHINIA Inc. All rights reserved
2
Publicité
