DBM MU 35 D Serie Notice D'utilisation Et D'entretien page 7

1.- INTRODUCTION
This service manual is intended for users of type MU 35/55 D. It contains the instructions for installation,
service and maintenance.
Before proceeding to do any kind of work on the equipment, users should read this manual carefully and
pay attention to any suggestions and tips given in it, particularly the ones preceded by the following safety
symbols:
Failure to observe these instructions may expose people to serious danger for their
health.
Failure to observe these instructions may expose people to electrical risks.
TAKE NOTE Any instructions preceded by this message are of great importance for proper
installation, use and maintenance.
In order to improve the final result of its products, the manufacturer. Reserves the right to modify the
content of this manual and/or the product itself with no need to inform its customers beforehand.
Failure to comply with the suggestions and recommendations in this manual, as well as improper use or
non-authorized handling of the product, shall fully release the manufacturer. From any liability as regards
possible damage caused, whether this be personal or material.
2.- DESCRIPTION AND USE
Electrically driven, multistage pumps high efficiency and low running cost together with it's low noise
emission make it an ideal choice for pressurized water systems, water sprinklers, etc. Maximum operating
temperature up to 35º C. Compact design with integral shaft of the motor pump and impellers made of
stainless steel.
3.- GUARANTEE
Equipment is guaranteed period of 12 months from delivery date, against any flaw in materials and
manufacture, according to the general sales terms. Failure to comply with the suggestions and
recommendations in this manual, as well as any improper use or non-authorized handling of the product,
will completely invalidate the guarantee.
The guarantee excludes wear and tear through use, improper use, repair or replacement of the faulty part
by the user or by unqualified staff without the express consent of manufacturer.
4.- RECEPTION OF THE GOODS
On reception of the goods please check that:
• The packaging has not undergone any damage during transport. Otherwise immediately make
the relevant claim to the forwarder.
• The material supplied coincides with the order specifications.
• The material has not undergone any damage during transport.
• The Technical Manual is included with the material.
6