Introduction:
This smart TV power saver is designed to cut down the standby power consumption
of your connected TV in order to reduce the energy costs and therefore save money.
This power saver will automatically turn off the power after you've put the TV in
standby mode. The EL-ESO2FHQ is very easy to operate, since it works with your
original remote control for your TV, SAT, HiFi or DVD player.
Operation:
Manual ON/OFF/
Reset switch
Operation Indicator
Light
IR Signal Receiver
1)
Plug the electrical appliance's plug into the socket on the front of the
EL-ES02FHQ. If you wish to connect more appliances, please connect a suitable
power board to the EL-ES02FHQ, and plug all appliances as a TV, DVD and
Power Amplifier on this power board and turn the power board ON
2)
If required, place the external IR sensor in front of your electrical appliance. Then
use that appliance's remote control to operate the EL-ES02FHQ
3)
The EL-ES02FHQ saver uses the IR remote control of various devices to operate.
This must be done in a straight line of sight without any obstacles between it
4)
Place the EL-ES02FHQ into an available wall socket, and ensure mains power is
available
5)
The indicator light on the front of the unit will flash after being connected to the
wall socket. Press any key on your appliance's remote control for the learning
mode to begin, please wait until the indicator light is illuminated
6)
Set all electrical appliances connected to the EL-ES02FHQ to be in stand by
mode. After waiting for a minimum of 30 seconds, press the ON/OFF key on the
EL-ES02FHQ, the indicator light will then turn off. The EL-ES02FHQ settings are
now completed
7)
If you wish to change the number of connected appliances, please press the reset
key on the EL-ES02FHQ for a period of 4 seconds continuously until the indicator
light flashes to indicate clearing of the memory code. Then, repeat steps 5) and 6)
as shown above for re-setting again.
ENGLISH
Controlled Power
Socket
RJ45 IR Receiver
Socket
2
IR Signal Receiver