Samson AirLine AH1/QE Aerobics Mode D'emploi page 7

Guided Tour - AR1 Receiver
6: Unbalanced output* - Use this unbalanced high impedance
(5 - 10 K Ohm) 1/4" jack when connecting the AR1 to consumer
(-10) audio equipment. Wiring is as follows: tip hot, sleeve ground.
7: Balanced output* - Use this electronically balanced low
impedance (600 - 2500 Ohm) XLR jack when connecting the AR1
to professional (+4) audio equipment. Pin wiring is as follows:
Pin 1 ground, Pin 2 high (hot), and Pin 3 low (cold).
Wall-mount AR1 receiver holder
8: Mute (squelch) control -
This control determines the
maximum range of the AR1
before audio signal dropout.
Although it can be adjusted
using the supplied plastic
screwdriver, it should
normally be left at its factory setting. See the "Setting Up and Using Your AirLine System"
section on page 16 in this manual for more information.
9: DC input - Connect the supplied 12 volt 200 mA power adapter here.
WARNING: Do not substitute any other kind of power adapter; doing so can cause
severe damage to the AR1 and will void your warranty.
As shown in the illustration on the left, the supplied AR1 receiver holder can be used to
wall-mount the AR1 in fixed installations.
* If required, both the balanced and unbalanced outputs can be used simultaneously.
5
Samson AirLine