Sharp DF-A1E Manuel D'utilisation page 12

11
• Your aroma diff user water tank is made with an anti-bacterial
material which prevents the build-up of micro-organisms. Be
careful not to damage the water tank.
• Some essential oils contain pigments which may tarnish or
stain the unit. Ensure that care is taken when using these and
clean the unit after use.
Description of the Aroma Diff user
1 Main Parts of Your Aroma Diff user on page 1).
(Refer to the
Your Aroma Diff user consists of the following parts:
1. Power Cable
2. AC Adaptor
3. Power input
4. Lid
5. Water Cup
6. Maximum mark
7. Ultrasonic Membrane
8. On/Off button
9. Light control button
10. Air outlet opening (When fi lling make sure that no water
enters this opening)
11. Fan
Controls
On/Off button (item 8)
To turn the unit on and off use the
the side of the unit and requires a simple push to turn on. When
the button is pressed it will click. Press once to turn on, press
again to turn off .
Light button (item 9)
It is possible to control the intensity of the light by pressing the
light button. This button operates as below if the light is on.
1. Press once – light dims.
2. Press again – light turns off .
3. Press again – light turns on at maximum level.
4. Pressing the button repeats 1 to 3 as above.
Top tips and hints
For trouble free use of your SHARP Aroma Diff user, follow
the advice in this user manual and the bullet points below:
• DO NOT block the fan grill as this will cause the mist not to be
• Fill the cup to the maximum water level prior to use and
• Make sure that the lid is always fi tted correctly.
Using your new Aroma Diff user
Before fi lling your Aroma Diff user with water, either turn off via
the
Fill the water cup to the maximum mark indicated. Do you not
exceed the maximum mark as this will cause the Aroma diff user
not to operate correctly and cause spillage of water.
This Aroma Diff user is designed to be used with clean water,
ideally this should be distilled water or if this is not available
you can use clean tap water. Once the cup has been fi lled to the
maximum level essential oils can be added to the water. Be sure
to follow the essential oil instructions to ensure that the correct
amount is used.
(Refer to the
Replace the lid, ensuring that it is correctly aligned and fi tting
snugly into the base of the unit. If the lid is not installed
correctly there will be a gap between it and the base which will
button this is located on
allow water to drip down the side of the unit. If the lid does not
fi t correctly rotate and try again.
(Refer to the
Once the lid has been correctly fi tted, it is possible to turn
on the unit. To do this press the on off
the side. The unit will power up and the LED will be at full
brightness.
emitted correctly.
when being used with the Auto Restart function.
button on the front or disconnect from the mains supply.
2 Water Level Mark on page 1).
3 Correct Fitment of Lid on page 1).
button located on