Publicité
Les langues disponibles
Les langues disponibles
13/ Outputs to Euroblock loudspeakers
14/ AC220-240V power supply input on blue powercon
Check that the voltage selected on the IEC power connector is suitable for your location. Connect the power cord to
an earthed socket.
COMMISSIONING
To prevent noise when switching the amplifier on and off, please :
-
When switching on, first switch on the other elements of the audio chain (mixer, EQ, processors, etc.).
-
When switching off, switch off the amplifier first, then the other components of the audio system.
Operating mode selection (Stereo / Bridge / Parallel)
-
Stereo: each channel is independent
-
Bridge: the signal from channels 1-2, 3-4, 5-6 is sent to the Bridge (red) outputs. So only volume settings 1 on
2C, 1-3 on 4C and 1-3-5 are active on 6C.
-
Parallel: the signal from channels 1-2, 3-4, 5-6 is sent to outputs 1 to 6, but the inputs are shared.
MAINTENANCE
Disconnect from mains before servicing.
There are no user-accessible parts; maintenance must be carried out by MSC Distribution.
If the power cable is damaged, always replace it with a similar one.
Always keep air inlet and outlet openings clean and free of obstructions.
TECHNICAL DATA
Power supply
Amplification class
Balanced/unbalanced input impedance
Input sensitivity
Frequency response
RMS output power
(1KHz THD <0.5%)
Stereo 8 ohms
2x 400W
Stereo 4 ohms
2x 80W
Stereo 2.7 ohms
2x 1200W
100V
2x 200W
Bridge 8 ohms
1x 1500W
/100V
HYBRID-2C
100-240VAC - 50/60Hz
20k ohms / 10K ohms
20Hz - 20KHz +/-0.5 dB
4x 400W
4x 800W
4x 1200W
4x 200W
2x 1500W
HYBRID-4C
Class D
1V
6x 400W
6x 800W
6x 1200W
6x 200W
3x 1500W
HYBRID-6C
8
Publicité
