HPA HYBRID-2C Mode D'emploi page 7

The device must not be exposed to extreme temperatures during operation (not
below 5°C and not above 35°C).
The device may only be used indoors.
Do not place naked flames, such as candles, on or near the unit.
Do not expose batteries to excessive heat (sunlight, fire, etc.).
When the power cord or a device coupler is used as a disconnect device, this
device must remain easily accessible.
IMPORTANT NOTE: electrical products must not be disposed of with household waste.
Please have them recycled where recycling centers exist. Consult your local authorities or dealer for information
on how to recycle them.
Complies with CE standard requirements
Recycled products are recyclable
For indoor use only
FRONT CONTROL PANEL
1/ ON / OFF switch
2/ Power LED
3/4/5: Channel LED ½ (2C) - 1/2/3/4 (4C) - 1/2/3/4/5/6 (6C)
Clip: lights up when the input signal is too high and may cause distortion.
Prot: lights up when protection is active on the channel
Signal: lights up when a signal is present in input A/B
6/ Channel output volume
7/ Bridge LED: lights up when bridge mode is activated
REAR PANEL
8/ Balanced XLR 3-pin signal inputs
9/ Balanced XLR 3-pin signal link outputs
10/ Mode selector. STEREO / BRIDGE / PARALLEL
11/ Speakon speaker outputs
12/ Red Speakon bridge outputs
7