Olympia NC 520 Mode D'emploi page 15

6
When the rubber tongue has worn too much (
must be turned around or replaced.
7
Æ Switch the machine off and disconnect the power plug.
Æ Press the rubber tongue downwards and remove it.
Æ Turn the rubber tongue and reinstall it
Æ or install a new rubber tongue.
Æ The recesses in the rubber tongue (
pushed in as far as possible (
Technical Data
Model
Infeed tray and output tray ca­
pacity
Counting speed
Thickness of bank notes
Power supply
Power consumption
Temperature and rel. humidity
Dimensions
Weight
All manuals and user guides at all-guides.com
7), it
Slight wear
Heavy wear
8-B) must be
8-A).
NC 520 / NC 540 / NC 560 / NC 570
100 old bank notes, 200 new bank notes
1,000 bank notes / minute
0.075 mm to 0.15 mm
230 V/ 50 Hz
50 W
0 to 40 °C; 30 to 95% relative humidity
325 x 244 x 154 [mm]
5.0 kg
G
8
Software Update
Æ Download the "update.bin" file from the Olympia
homepage (www.olympia-vertrieb.de).
Æ Load the "update.bin" on a Micro-SD memory card.
Æ Switch the machine off.
Æ Insert the Micro-SD memory card in the corresponding
slot provided on rear of the machine. The contacts must
point downwards.
Æ Switch the machine on. Ê During the upgrade pro­
cess, the machine produces a noise and the display re­
mains empty.
When the upgrade has been completed, the noise stops
and the display appears as normal.
If you want to complete the software update on
several machines, set the "update.bin" file attribute
to "read only".
A B
15